Key Takeaways

  • The LE270-EU and LE271-GL modules connected to SpaceX Starlink Direct to Cell without satellite-specific hardware changes.
  • Open-sky tests delivered up to approximately 2.2 Mbps downlink, but indoor obstructions materially reduced performance.
  • Satellite uploads consumed 1.5 to 1.8 times more energy than terrestrial cellular uploads, creating a design trade-off for battery-powered IoT devices.

Fibocom reported live-network testing in New Zealand where its LE270-EU and LE271-GL LTE Cat.1 bis modules connected to SpaceX Starlink Direct to Cell using standard firmware and without satellite-specific hardware modifications.

An IoT manufacturer could potentially add out-of-coverage communications without integrating a separate satellite modem and antenna system. This approach reduces hardware complexity, certification work, and the physical space allocated to communications components, while simplifying inventory for products deployed across connected and remote areas.

According to the field-test report, the LE270-EU achieved approximately 2.2 Mbps downlink under open-sky conditions, while the LE271-GL reached about 2.0 Mbps. Both modules produced approximately 0.3 Mbps uplink. Network registration took roughly 1 to 30 seconds, and ping success rates reached 80% to 90% outdoors and inside vehicles with good sky visibility.

Those figures are sufficient for many IoT workloads. Asset-location updates, equipment diagnostics, environmental readings, and short operational messages generally require far less bandwidth than consumer video or other data-heavy services. Even image uploads or larger firmware-related exchanges may be practical if applications tolerate variable transfer times.

The tests demonstrate that terrestrial and satellite connectivity are not strictly interchangeable. Obstructed indoor conditions materially reduced performance, with some trials recording approximately 0.5 Mbps downlink and ping success rates of 65% to 70%. Buildings, vehicle structures, terrain, and antenna placement can all complicate the path between a low-power device and a satellite.

Energy use presents another constraint. Uploading the same file over Starlink Direct to Cell consumed approximately 1.5 to 1.8 times more energy than sending it through a terrestrial cellular network. For a powered vehicle tracker, that increase may be manageable. For a remote sensor expected to operate for years from a small battery, it could change reporting intervals, battery sizing, and the device's overall maintenance model.

Satellite service does not need to replace the primary mobile connection to be useful. A device could favor terrestrial LTE when it is available, then use Direct to Cell for periodic status reports, emergency alerts, or delayed data delivery outside normal coverage. RuntimeWire characterized the result as a possible route to out-of-coverage reporting without adding a second radio.

While the results suggest satellite support could become a firmware and network-service decision rather than a hardware redesign, commercial deployments will still depend on operator support, roaming arrangements, spectrum authorization, device certification, and service availability in each market.

The broader technical direction comes from cellular integration with non-terrestrial networks. 3GPP has developed standards work intended to bring satellite access into the cellular ecosystem, allowing established mobile technologies and network architecture to support non-terrestrial coverage. The recent testing offers a practical example involving LTE Cat.1 bis, a category widely suited to moderate-throughput IoT applications.

These performance numbers were company-reported rather than produced through an independent benchmark, representing particular devices, network conditions, and test environments in New Zealand. Manufacturers will need their own trials across antenna orientations, enclosures, weather conditions, mobility patterns, and power profiles before making deployment assumptions.

Agriculture sensors, logistics equipment, environmental monitors, and mobile assets often move between strong terrestrial coverage and complete dead zones. If standard LTE modules can retain basic communications in those gaps, device makers may gain a broader coverage option without carrying the cost and complexity of two separate radio designs.

For now, the most credible role is fallback connectivity rather than universal broadband. Fibocom's field results show throughput suitable for IoT workloads under clear skies, weaker behavior around obstructions, and a measurable battery penalty. This combination offers IoT engineering teams an additional communications path when the terrestrial network disappears.